WarmlyYours PRO-Tect 80 ft. Electric Heat Tape for Water Pipes with Thermostat - Plug-in Pipe Heating Cable for Freeze Protection, 7 W/ft, 120V

A burst water pipe in the dead of winter can be a huge inconvenience and completely replacing the insulation needed to prevent pipes in perimeter walls and crawlspaces from freezing can be cost-prohibitive. To keep your most vulnerable pipes from freezing, the simple and DIY-friendly solution is to install a PRO-Tect heating cable for pipes. This 120 V plug-in heating cable generates heat (7 watts per linear foot) which will keep your pipes from freezing in low temperatures. The integrated thermostat control, located between the non-heating lead cable and the heating wire itself, will ensure a consistent temperature while minimizing energy use. The thermostat turns the heating cable on when exposed to temperatures below 37.4 F (3 C). It will shut the heating cable off when the pipe has been heated to a temperature of approximately 50 F (10 C). The cable is covered by a 2-year warranty.