FARM TRACTOR MAINTENANCE 1940s INSTRUCTIONAL FILM 55344

Video Description

This black and white film about tractor maintenance is a training film produced by the U.S. Office of Education, Federal Security Agency, between 1934 and 1948 as J.W. Studebaker is listed as the Commissioner of Education. It is #6 in the series of “Farm Work Equipment Maintenance.” All maintenance is shown up close and the timestamps given began that task. It opens with a man on a International Harvester Farmall bringing his tractor in to perform maintenance (:33) Each owner’s manual (1:01) details that brand of tractor’s maintenance; however, this film presents the following tasks as common to all. After every 10 hours of operation or daily, inspect the air cleaner cap (1:24); change out the air cleaner oil cup (1:42); when operating on distillate, check the oil level in the crankcase via the two petcocks (2:27); when operating on gasoline, check the oil level in the crankcase via the upper petcock (3:14); lubricate the water pump shaft using the grease required for your tractor (3:50); lubricate the rear axle bearings (4:05); lubricate the steering assembly (4:20 ); lubricate the clutch release shaft (4:53); and lubricate the starting crank bearing (5:08). After 60 hours of operation or once a week, the required maintenance is to remove and clean the air cleaner (5:23); inspect the carburetor air hose for damage (6:14); inspect the fan belt for damage (6:44); clean the spaces in the radiator fins or shutters (6:58); lubricate the fan hub bearing (7:22); lubricate the impulse coupling (7:34); lubricate the clutch release bearing (7:47); and lubricate the clutch pilot bearing (8:06). After 120 hours of operation or twice a month, the required maintenance is to replace the oil filter element, and drain and change the engine crankcase oil (8:28). After 250 hours of operation or monthly, the required maintenance is to take apart and clean the fuel line assembly (10:51); remove, clean, and check the gap in the spark plugs (12:27); and clean the chamber and check the gap of the magneto breaker points (14:31). After 400 hours of operation, the required maintenance is to drain and clean the cooling system (15:03); check for clearance in the engine valves (16:55); check for free movement in the clutch pedal (17:58); check for free movement and equalization in the brake pedals (18:22); lubricate the distributor bearing (18:43); and lubricate miscellaneous moving parts (19:04). After 1,000 hours of operation, the required maintenance is to drain and change the oil in the transmission case (19:34); drain and change the oil in the steering warm gear (20:13); and remove, clean and repack the front wheel bearings (20:31). Another daily task is to check that your tires are properly inflated (21:01). A final reminder is to always refer to the owner’s manual for your tractor. We encourage viewers to add comments and, especially, to provide additional information about our videos by adding a comment! See something interesting? Tell people what it is and what they can see by writing something for example: "01:00:12:00 -- President Roosevelt is seen meeting with Winston Churchill at the Quebec Conference." This film is part of the Periscope Film LLC archive, one of the largest historic military, transportation, and aviation stock footage collections in the USA. Entirely film backed, this material is available for licensing in 24p HD, 2k and 4k. For more information visit http://www.PeriscopeFilm.com